Effects Loop Assembly
You get to make a lot of fun bits with this build and this is one of them. This 18g Bus wire was bent using round nose jewelers pliers.
Two RG188U coaxial cables that will terminate here for the effects loop. They will fit in these loops with the shield wire exposed (outer jacket stripped)
to complete the ground. (see C3 schematic for placement and wiring)
Another fun bit of wire. These two pieces of BUS wire slip in like this for a fitting.
Solder these to the bottom jack only at this time & trim excess
Fit 1M resistor and solder it to the loop lug for now. Leave the other end loose. Trim up ends. That is it until final connections.
Install the Return Coax and solder both ends. The other end terminates at V4 Preamp.
